Projects / Foundry and mid-sized companies

Case example

Reconstructing a casting pattern: Benelli clutch cover

Original part scanned, reconstructed as a CAD model and compared against the scan.

My role: scanning, reconstruction, comparison. Status: completed.

Original and printed reproduction
Original and printed reproduction
Problem

Only the original part of the clutch cover existed. The data for a casting pattern was missing.

Turning point

The colour comparison of scan and CAD shows where the model deviates from the original.

Result

The CAD model is the basis for a casting pattern.

Task

Initial situation

The clutch cover of a Benelli existed only as an original part. The data for a casting pattern was missing.

Requirements and key data
  • Original part without a drawing
  • Scan, CAD model and colour comparison
  • Tolerance in the comparison: ± 0.1 mm
  • The printed model verifies the geometry, not the strength
Images

From the project

Clutch cover in its initial condition
Clutch cover in its initial condition
Colour comparison of scan and CAD
Colour comparison of scan and CAD
Approach

The steps

  1. ScanCapture the original part.
  2. ReconstructionCAD model from the scan data.
  3. ComparisonMake deviations visible in a colour map.
Result

What came out of it

  • The CAD model is the basis for a casting pattern.
  • The printed comparison model proves the geometry, not the strength in use.

For your company

The approach suits any company with existing parts but no data: capture, test on the part, then decide. To the industry page Foundry and mid-sized companies

Do you have a similar task?

Tell me briefly what it is about.

Describe your taskCall