Motorsport and vehicle engineering
Designing parts in the vehicle scan.
In motorsport the deadline is fixed. I scan the installation space, design inside the scan and check the fit before manufacturing.
Typical tasks
- A part is to be retrofitted without changing the structure.
- The installation space is tight and not documented.
- An existing part is to be adapted.
- The team should be able to use new technology itself.
Customer project
Intake funnel for CVT ventilation
Two-piece intake funnel on the roll cage. Clamped, not drilled, not welded.
- The final part is printed from glass-fibre-reinforced TPU (rubber-like plastic).
- The fit was checked digitally against the scan before printing.
Same team
Holder for the winch remote control
The winch remote control gets a fixed place in the cockpit of the race vehicle.
- The holder sits in the cockpit of RZR #2812.
- It was used off-road in Johnson Valley.
For your company
What you can take from this
Retrofitting without drilling into or welding on the structure: this applies to machines and plants just as well.
Do you have a similar task?
Tell me briefly what it is about.





