Projects / Motorsport and vehicle engineering

Collection

Vehicle parts: scan, reconstruct, adapt

Ten smaller tasks around the vehicle. Most of them start with a 3D scan.

My role: scanning and design.

Audi RS4: intake manifold during the scan
Audi RS4: intake manifold during the scan
Task

Initial situation

Data is often missing on the vehicle: for an add-on part, a conversion or a cover. The scan provides the basis.

Requirements and key data
  • Intake manifold Audi RS4 2.7 Biturbo: 3D scan on behalf of a customer as the basis for an adaptation
  • Engine bay BMW E30 with V8: 3D scan after the conversion
  • Roof rails: matching seals designed and printed from TPU (rubber-like plastic)
  • ATV: clipless pedals with a mount on the vehicle and an adapter on the shoe
  • Racing kart trailer: holding fixture as a welded part
  • Exhaust manifold: flange face milled flat after coating. A two-component adhesive forms the form-fitting support in the clamping set-up
  • SLS (printing from plastic powder) part: post-processing after printing
  • Classic motorcycle: rubber damper scanned
  • Harley-Davidson XLCH (1965): puller for the sprocket built on behalf of a customer because the special tool was missing. Material: quenched and tempered steel 42CrMo4
  • Motorcycle: cracked housing cover repaired. Relief holes at the crack ends, TIG-welded, then stress-relieved in the oven
Images

From the project

Audi RS4: the intake manifold on the welding table, behind it the scan data
Audi RS4: the intake manifold on the welding table, behind it the scan data
BMW E30: engine bay before the scan
BMW E30: engine bay before the scan
Roof rails: printed TPU seals
Roof rails: printed TPU seals
Roof rails: seal mounted on the vehicle
Roof rails: seal mounted on the vehicle
ATV: mount for the clipless pedal
ATV: mount for the clipless pedal
ATV: adapter on the shoe
ATV: adapter on the shoe
ATV: off-road
ATV: off-road
Show more images (8)
Racing kart trailer: parts of the holding fixture
Racing kart trailer: parts of the holding fixture
Exhaust manifold in the clamping set-up, with a support made of two-component adhesive
Exhaust manifold in the clamping set-up, with a support made of two-component adhesive
Exhaust manifold: milling the flange face flat
Exhaust manifold: milling the flange face flat
SLS part during depowdering
SLS part during depowdering
Classic motorcycle: rubber damper during the scan
Classic motorcycle: rubber damper during the scan
Classic motorcycle: scan data of the rubber damper
Classic motorcycle: scan data of the rubber damper
Harley-Davidson XLCH: the self-built puller for the sprocket
Harley-Davidson XLCH: the self-built puller for the sprocket
Housing cover: crack with relief holes, then the TIG weld
Housing cover: crack with relief holes, then the TIG weld
Approach

The steps

  1. ScanCapture the part or the installation space.
  2. PrepareDepending on the task: data set, design or printed part.
Result

What came out of it

  • From the scan to the finished part: the route follows the task.

For your company

Retrofitting without drilling into or welding on the structure: this applies to machines and plants just as well. To the industry page Motorsport and vehicle engineering

Do you have a similar task?

Tell me briefly what it is about.

Describe your taskCall