Projects / Workshop and more

Workshop

Underbody scan on the Jeep: overview and details in one model

Underbody of my Jeep scanned at two resolutions. The amount of data follows the requirement.

My role: scanning and evaluation.

Combined model of the underbody
Combined model of the underbody
Problem

The underbody was to be available digitally as the basis for design.

Turning point

Only as much data as necessary: 0.5 mm across the surface, 0.2 mm at the mounting points.

Result

One model with the whole geometry and precise mounting points.

Task

Initial situation

The underbody of my Jeep was to be available digitally as the basis for design. A scan at high resolution throughout would have produced an unnecessary amount of data.

Requirements and key data
  • Whole underbody at 0.5 mm resolution
  • Mounting points as a detail at 0.2 mm resolution
  • Reference markers combine both scans into one model
  • Basis for reverse engineering (a CAD model is built from the scan) in CAD
Images

From the project

High resolution at the mounting points: 0.2 mm
High resolution at the mounting points: 0.2 mm
Reference markers on the underbody connect the scans
Reference markers on the underbody connect the scans
Approach

The steps

  1. Register the markersCapture global markers on the underbody.
  2. Scan the overviewWhole underbody at 0.5 mm.
  3. Scan the detailsMounting points at 0.2 mm.
  4. CombineConnect and align both scans via the marker file.
Result

What came out of it

  • One model with the whole geometry and precise mounting points.
  • Lesson learned: only as much data as necessary. The resolution follows the requirement, coarse across the surface and fine at the mounting points.

Do you have a similar task?

Tell me briefly what it is about.

Describe your taskCall